Gasoline Pressure [email protected]’S MANUALModel: PGPW2700H-A
10ASSEMBLYPacking List• Pressure washer• Quick start guide• Operator’s manual and product registration card• Spray gun• Engine manualExtension wand wi
11ASSEMBLY• Parts needed - 1 foot, 1 M8 lock nuts.• Raise or tilt pressure washer so you can line up foot with the hole located at the centre of the f
12ASSEMBLY• Screw the spray wand and the trigger handle together until they are secure.•nut on by turning clockwise until it is hand tight.FIG 4FIG 5A
13ASSEMBLY• Place pressure washer on a level surface.•• Carefully add between 520 ml (17.6 oz) of 4-Cycle engine oil (SAE10W30) to empty reservoir unt
14ASSEMBLY• • Inspect inlet screen and remove any debris.• Connect hose to water inlet and tighten by hand. There must be a minimum of 10 feet of un
15Pre-Operation Check List• Read and understand this operator manual in its entirety before operating pressure washer.• Check oil level and add oil to
16Stopping Pressure Washer (See Fig 12)• Turn the on/stop switch to the OFF position.• Turn the fuel valve to the OFF position.• Turn off water and
17Using Spray Nozzle (See fig 15)• To connect or disconnect spray tip, pull back on the quick-connect collar. Insert or remove spray tip then release
18Regular maintenance will extend the life of this pressure washer and improve its performance. The warranty does not cover items that result from op
19High Pressure Hose• Inspect hose for cuts, bulges, or leaks which can develop from kinking or wear. If damage is found, immediately replace hose.• I
SAVE THIS MANUAL FOR FUTURE REFERENCEThis manual contains important information regarding safety, operation, and maintenance. Introduction ...
Checking Spark Plug• Disconnect the spark plug wire from the spark plug.• Before removing the spark plug, clean the area around its base to prevent
21Engine does not start 1. Out of fuel2. Engine oil low3. Spark plug wire disconnected from spark plug4. Bad spark plug5. Spark plug wire has sho
22WARRANTYPulsar Limited 2 Year Warranty:From the date of original purchase, Pulsar warrants to the original purchaser, that each pressure washer sold
23WARRANTYWhat this Warranty Does Not Cover:• Normal wear: This warranty excludes normal wear items such as hoses, connector fittings, spray nozzles,
3INTRODUCTIONDate of Purchase: Model Number: Serial Number:Thank you for purchasing this superior quality pressure washer from Pulsar. When operating
4Indicates a potentially hazardous situation which could result in serious injury or death if not avoided.Slippery surfaceRisk of explosionRisk
5• The high pressure stream of water produced can cut through skin and underlying tissue. Never squeeze the trigger or point the spray gun at other p
6alcohol, drugs, medication or you feel tired.Stay alert and use common sense. Do not operate this unit if you are under the influence ofWARNING!• Al
7PRESSURE WASHER FEATURESA - 25’ High Pressure HoseB - Fuel Tank and capC - ChokeD - Fuel Valve LeverE - Siphon Tube with StrainerF - HandleG - Spray
8PRESSURE WASHER PARTS ASSEMBLY
PRESSURE WASHER PARTS LISTNUMBER ITEM NAME QTY1180CC Engine12Lower "A" Frame assembly13M8 Self-Lock Nut14Rubber Feet15Round Head Bolt M6 x45
Kommentare zu diesen Handbüchern